Citation: | WANG Zhipeng, ZHU Mingliang, XUAN Fuzhen. High cycle fatigue property and lifetime modeling of CrMoV and NiCrMoV dissimilar steel welded joint[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2024, 45(7): 67-73. DOI: 10.12073/j.hjxb.20231205004 |
CrMoV and NiCrMoV dissimilar steel welded joints were subjected to high cycle fatigue tests at room temperature and 400 ℃, fracture analysis was carried out on the failed specimens to study the high cycle fatigue failure mechanism of dissimilar steel welded joints. The results show that the S-N curves showed a continuous decrease, and there is no fatigue limit plateau observed during high cycle fatigue, while all the failure locations were located in the weld metal region, which was defined as the structurally weak zone with lower micro-hardness; with the increase of the high fatigue lifetime, the crack initiation mode was changed from the competition between surface and internal initiation to the dominated internal micro-defect initiation, the internal weld porosity micro-defects were the main source of crack initiation; The fatigue limits obtained by the Murakami model were dispersive and there was no apparent law between high cycle fatigue life. By introducing the Z parameter model, it was pointed out that the high cycle fatigue lifetime of welded joint was determined by the stress level, effective size and relative depth of micro-defects, and the Z parameter had a good linear relationship with the high cycle fatigue lifetime.
[1] |
Wang W K, Zhang J X, Zhong J. Comparative evaluation of LCF behavior of dissimilar steels and welds in an ultra-supercritical turbine rotor at 280 ℃[J]. International Journal of Fatigue, 2020, 139: 105771. doi: 10.1016/j.ijfatigue.2020.105771
|
[2] |
Maurya A K, Pandey C, Chhibber R. Dissimilar welding of duplex stainless steel with Ni alloys: A review[J]. International Journal of Pressure Vessels and Piping, 2021, 192: 104439. doi: 10.1016/j.ijpvp.2021.104439
|
[3] |
黄毓晖, 司晓法, 翁硕, 等. 疲劳损伤对核电汽轮机焊接转子接头应力腐蚀开裂敏感性的影响[J]. 焊接学报, 2020, 41(4): 12 − 19,37.
Huang YuHui, Si Xiaofa, Weng Shuo, et al. Effect of fatigue damage on stress corrosion cracking sensitivity of nuclear steam turbine welded joint[J]. Transactions of the China Welding Institution, 2020, 41(4): 12 − 19,37.
|
[4] |
Wang D, Yao D, Gao Z, et al. Fatigue mechanism of medium-carbon steel welded joint: Competitive impacts of various defects[J]. International Journal of Fatigue, 2021, 151: 106363. doi: 10.1016/j.ijfatigue.2021.106363
|
[5] |
谢琦, 王娜, 杨雅静, 等. 含缺陷钢结构焊接接头检测与评估[J]. 机械工程学报, 2021, 57(24): 223 − 232. doi: 10.3901/JME.2021.24.223
Xie Qi, Wang Na, Yang Yajing, et al. Detection and evaluation of welded joints of steel structures with defects[J]. Journal of Mechanical Engineering, 2021, 57(24): 223 − 232. doi: 10.3901/JME.2021.24.223
|
[6] |
刘龙隆, 轩福贞, 朱明亮. 25Cr2Ni2 MoV钢焊接接头的超高周疲劳特性[J]. 机械工程学报, 2014, 50(4): 25 − 31. doi: 10.3901/JME.2014.04.025
Liu Longlong, Xuan Fuzhen, Zhu Mingliang. Very high cycle fatigue behavior of 25Cr2Ni2 MoV steel welded joint[J]. Journal of Mechanical Engineering, 2014, 50(4): 25 − 31. doi: 10.3901/JME.2014.04.025
|
[7] |
靳晓坤, 张世超, 刁旺战, 等. 时效时间对SP2215同种钢焊接接头微观组织和力学性能的影响[J]. 焊接学报, 2023, 44(9): 95 − 105.
Jin Xiaokun, Zhang Shichao, Diao Wangzhan, et al. Effect of aging time on the microstructure and mechanical properties of the the SP2215 steel welded joint[J]. Transactions of the China Welding Institution, 2023, 44(9): 95 − 105.
|
[8] |
轩福贞, 朱明亮, 王国彪. 结构疲劳百年研究的回顾与展望[J]. 机械工程学报, 2021, 57(6): 26 − 51. doi: 10.3901/JME.2021.06.026
Xuan Fuzhen, Zhu Mingliang, Wang Guobiao. Retrospect and prospect on century-long research of structural fatigue[J]. Journal of Mechanical Engineering, 2021, 57(6): 26 − 51. doi: 10.3901/JME.2021.06.026
|
[9] |
Zhu M L, Xuan F Z, Du Y N, et al. Very high cycle fatigue behavior of a low strength welded joint at moderate temperature[J]. International Journal of Fatigue, 2012, 40: 74 − 83. doi: 10.1016/j.ijfatigue.2012.01.014
|
[10] |
Wang W K, Liu Y, Guo Y, et al. High cycle fatigue and fracture behaviors of CrMoV/NiCrMoV dissimilar rotor welded joint at 280 ℃[J]. Materials Science and Engineering: A, 2020, 786: 139473. doi: 10.1016/j.msea.2020.139473
|
[11] |
Shao C, Lu F, Cui H, et al. Characterization of high-gradient welded microstructure and its failure mode in fatigue test[J]. International Journal of Fatigue, 2018, 113: 1 − 10. doi: 10.1016/j.ijfatigue.2018.03.029
|
[12] |
Wang N, Jin L, Zhu M L, et al. Effect of hydrogen on very high cycle fatigue behavior of a low-strength Cr-Ni-Mo-V steel containing micro-defects[J]. Procedia Structural Integrity, 2017, 7: 376 − 382. doi: 10.1016/j.prostr.2017.11.102
|
[13] |
Zhu M L, Liu L L, Xuan F Z. Effect of frequency on very high cycle fatigue behavior of a low strength Cr–Ni–Mo–V steel welded joint[J]. International journal of fatigue, 2015, 77: 166 − 173. doi: 10.1016/j.ijfatigue.2015.03.027
|
[14] |
Zhu M L, Xuan F Z. Failure mechanisms and fatigue strength assessment of a low strength Cr-Ni-Mo-V steel welded joint: Coupled frequency and size effects[J]. Mechanics of Materials, 2016, 100: 198 − 208. doi: 10.1016/j.mechmat.2016.06.017
|
[15] |
康举, 王启冰, 王智春, 等. 超超临界火电机组异种钢焊接接头高温断裂机理综述[J]. 机械工程学报, 2022, 58(24): 58 − 83. doi: 10.3901/JME.2022.24.058
kang Ju, Wang Qibing, Wang Zhichun, et al. A review on high temperature rupture mechanisms of dissimilar metal welded joints for the usc thermal power units[J]. Journal of Mechanical Engineering, 2022, 58(24): 58 − 83. doi: 10.3901/JME.2022.24.058
|
[16] |
Wu Z, Liu S, Yang Z, et al. Simultaneously improved the strength dramatically and eliminated HAZ softening of DP980 steel pulsed-arc welding joints by PWHT[J]. Materials Science and Engineering: A, 2022, 837: 142752. doi: 10.1016/j.msea.2022.142752
|
[17] |
Jorge J C F, Monteiro J L D, de Carvalho Gomes A J, et al. Influence of welding procedure and PWHT on HSLA steel weld metals[J]. Journal of Materials Research and Technology, 2019, 8(1): 561 − 571. doi: 10.1016/j.jmrt.2018.05.007
|
[18] |
Zhu M L, Xuan F Z, Wang Z. Very high cycle fatigue behavior and life prediction of a low strength weld metal at moderate temperature [C]// Proceedings of the ASME Pressure Vessels and Piping Conference. ASME, Baltimore, USA, 2011, 317 − 329.
|
[19] |
Kobayashi H, Todoroki A, Oomura T, et al. Ultra-high-cycle fatigue properties and fracture mechanism of modified 2.25 Cr–1 Mo steel at elevated temperatures[J]. International journal of fatigue, 2006, 28(11): 1633 − 1639. doi: 10.1016/j.ijfatigue.2005.08.016
|
[20] |
Li G, Sun C. High-temperature failure mechanism and defect sensitivity of TC17 titanium alloy in high cycle fatigue[J]. Journal of Materials Science & Technology, 2022, 122: 128 − 140.
|
[21] |
Murakami Y, Yokoyama N N, Nagata J. Mechanism of fatigue failure in ultralong life regime[J]. Fatigue & Fracture of Engineering Materials & Structures, 2002, 25(8-9): 735 − 746.
|
[22] |
Wu W, Zhu M L, Liu X, et al. Effect of temperature on high cycle fatigue and very high cycle fatigue behaviours of a low strength CrNiMoV steel welded joint[J]. Fatigue & Fracture of Engineering Materials & Structures, 2017, 40(1): 45 − 54.
|
[1] | LIU Xudong, SA Zicheng, FENG Jiayun, LI Haozhe, TIAN Yanhong. The Development Status On Advanced Packaging Copper Pillar Bump Interconnection Technology and Reliability[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION. DOI: 10.12073/j.hjxb.20240718001 |
[2] | YANG Dongsheng, ZHANG He, FENG Jiayun, SA Zicheng, WANG Chenxi, TIAN Yanhong. Research progress on micro/nano joining technologies and failure behaviors in electronic packaging[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2022, 43(11): 126-136. DOI: 10.12073/j.hjxb.20220702003 |
[3] | SUN Lei, ZHANG Yi, CHEN Minghe, ZHANG Liang, MIAO Naiming. Finite element analysis of solder joint reliability of 3D packaging chip[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2021, 42(1): 49-53. DOI: 10.12073/j.hjxb.20201021002 |
[4] | YANG Hong, LI Yulong, DONG Yangping, CUI Qingbo. Ultrasonic welding packaging of FBG and its bending sensing characteristics[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2019, 40(8): 69-75. DOI: 10.12073/j.hjxb.2019400211 |
[5] | HAN Lishuai, HUANG Chunyue, LIANG Ying, KUANG Bing, HUANG Genxin. Analysis of stress strain and shape size optimization of 3D micro-scale CSP solder joints in random vibration[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2019, 40(6): 64-70. DOI: 10.12073/j.hjxb.2019400156 |
[6] | XIONG Mingyue1, ZHANG Liang1,2, LIU Zhiquan2, YANG Fan1, ZHONG Sujuan3, MA Jia3, BAO Li3. Structure optimization design of CSP device based on Taguchi method[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2018, 39(5): 51-54. DOI: 10.12073/j.hjxb.2018390121 |
[7] | CUI Haipo, CHENG Enqing. Random vibration analysis of different electronic packaging structures[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2017, 38(7): 91-94. DOI: 10.12073/j.hjxb.20150606002 |
[8] | NAN Qiuming, WU Haoying, LI Sheng. Metallization packaging method for FBG vibration sensor[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2016, 37(2): 17-20. |
[9] | WANG Bo, MO Liping, WU Fengshun, XIA Weisheng, WU Yiping. Microstructure of solder joints with micron stand-off height in electronic packaging[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2011, (12): 25-28. |
[10] | YE Huan, XUE Songbai, ZHANG Liang, WANG Hui. Finite element analysis on reliability of lead-free soldered joints for CSP device[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2009, (11): 93-96. |
1. |
蒋宝,徐富家,杨义成,聂鑫,宋扬,刘孔丰. 万瓦级激光-电弧复合穿透焊接成形缺陷研究. 电焊机. 2022(10): 15-22 .
![]() |