高级检索
黄福祥, 杜则裕, 隋永莉, 曾惠林, 郭晓疆. 国产X80钢焊接冷裂敏感性的插销试验[J]. 焊接学报, 2009, (4): 89-92.
引用本文: 黄福祥, 杜则裕, 隋永莉, 曾惠林, 郭晓疆. 国产X80钢焊接冷裂敏感性的插销试验[J]. 焊接学报, 2009, (4): 89-92.
HUANG Fuxiang, DU Zeyu, SUI Yongli, ZENG Huilin, GUO Xiaojiang. Study on cold cracking susceptibility of domestic X80 pipeline steel using implant tests[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2009, (4): 89-92.
Citation: HUANG Fuxiang, DU Zeyu, SUI Yongli, ZENG Huilin, GUO Xiaojiang. Study on cold cracking susceptibility of domestic X80 pipeline steel using implant tests[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2009, (4): 89-92.

国产X80钢焊接冷裂敏感性的插销试验

Study on cold cracking susceptibility of domestic X80 pipeline steel using implant tests

  • 摘要: 用插销试验法研究了实心焊丝CO2气保焊根焊条件下X80管线钢的冷裂纹敏感性及断口特征.结果表明,预热100℃条件下X80钢的抗冷裂性好,临界断裂应力σcr为624 MPa,与其抗拉强度相当.当拘束拉伸应力高于抗拉强度时,将发生失效断裂,断裂性质为延性断裂断口.CO2气保焊进行根焊焊接时,X80钢的抗冷裂性好,与该方法能得到超低氢的焊接条件有关,此外还与该钢的裂纹敏感系数(0.17%)不高,HAZ淬硬不明显有关.焊接接头过热区的组织主要为块状铁素体,最高硬度297 HV。

     

    Abstract: Cold crack sensitivity and the fracture characteristic of the root pass welding of X80 pipeline steel CO2 gas shielded arc weld with solid wire was investrgated by implant testing.The results indicate that the X80 steel has the excellent resistance to cold cracking under the preheating 100℃ condition, the critical breaking stress σcr(624 MPa) is equivalent to its tensile strength Rm. When the tension stress is higher than Rm, the expiration break would happen, and the breaking nature is the ductile fracture.Under the condition of CO2 gas shielded arc weld for root pass, the good resistence to crack characteristic of X80 steel has not only been related with the welding procedure with the ultra low hydrogen welding, but also with the lower crack sensitive coefficient(0.17%) as well as the unobvious quench hardening of HAZ.The microstructure of superheat section, with the maximum hardness degree of 297 HV is mainly the block ferrite.

     

/

返回文章
返回