高级检索
经士农, 荒田吉明, 小林明, 羽原康裕. 气体隧道型等离子焰流基本特性的研究[J]. 焊接学报, 1991, (2): 96-102.
引用本文: 经士农, 荒田吉明, 小林明, 羽原康裕. 气体隧道型等离子焰流基本特性的研究[J]. 焊接学报, 1991, (2): 96-102.
Jing Shinong, Yoshiaki Arata, Akira Kobayashi, Yasuhiro Habara. Basic properties of gas tunnel type high power plasma jet[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1991, (2): 96-102.
Citation: Jing Shinong, Yoshiaki Arata, Akira Kobayashi, Yasuhiro Habara. Basic properties of gas tunnel type high power plasma jet[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1991, (2): 96-102.

气体隧道型等离子焰流基本特性的研究

Basic properties of gas tunnel type high power plasma jet

  • 摘要: 本文研究了气体隧道型等离子焰流的基本特性.为了查明沿气体隧道中心轴的压力特性.测量了在没有等离子焰流的条件下气炬涡流发生器中的压力分布.在喷嘴直径为4~8 mm的情况下,沿中心轴上气体隧道的压力是很低的(230×133 Pa).在这种低压气体隧道中产生的等离子焰流比一般方法产生的焰流更长,并具有良好的特性。它们是上升的伏-安特性;很高的电位梯度,当喷嘴直径为4 mm,电流为400 A时.电位梯度为41 V/cm;高的热效率;高的能量密度.由于在这种装置中供给喷涂粉末的方法与普通的装置不同,因此能显著地改善喷涂屋的质量。

     

    Abstract: The basic characteristics of a gas tunnel type plasma jet which is ejected into the open air are experimentally investigated.To clarify the properties of the gas tunnel along the center axis,the pressure in the vortex chamber of the torch was measured in the absence of the plasma jet.The pressure in the gas tunnel is as low as 230×1.33×102 Pa along the center axis with a gas diverter nozzle 4~8 mm in diameter.The plasma jet produced in this low-pressure gas tunnel is longer than a conventionally produced jet and has superior characters as follows.It has an extremely positive volt-ampere characteristic,and very high potential gradient,such as 41 V/cm at 400A when a gas diverter nozzle 4 mm in diameter is used,and high thermal efficiency and high energy density.In this apparatus the supplying method of the spraying powder is different from the conventional type.For this reason,the quality of the spraying coating can be pimproved remarkably.

     

/

返回文章
返回