高级检索
冯钟潮, 于尔靖, 朱鸿德, 杨海学. 铸造镍基合金焊接液化裂纹[J]. 焊接学报, 1983, (2): 79-86.
引用本文: 冯钟潮, 于尔靖, 朱鸿德, 杨海学. 铸造镍基合金焊接液化裂纹[J]. 焊接学报, 1983, (2): 79-86.
Feng Zhongchao, Yu Erjing, Zhu Hongde, Yang Haixue. INVESTIGATION ON THE WELDING LIQUATION CRACKS IN CAST Ni-BASE SUPERALLOYS[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1983, (2): 79-86.
Citation: Feng Zhongchao, Yu Erjing, Zhu Hongde, Yang Haixue. INVESTIGATION ON THE WELDING LIQUATION CRACKS IN CAST Ni-BASE SUPERALLOYS[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1983, (2): 79-86.

铸造镍基合金焊接液化裂纹

INVESTIGATION ON THE WELDING LIQUATION CRACKS IN CAST Ni-BASE SUPERALLOYS

  • 摘要: 本文用金相、相分析、电镜,特别是扫描电镜、电子探针等手段对铸造镍基合金焊接液化裂纹、焊接热影响区晶界经受焊接高温过程的变化进行了综合研究。提出了某些铸造镍基合金液化裂纹产生的机理:①在焊接高温下,沿晶界及晶界附近的γ+γ'共晶及其反应前缘富Zr等低熔物熔化;④沿晶界及晶界附近的TiC全部或部分溶解、产生"组分液化";③这些液相沿晶界漫流形成液化晶界的部分在焊接收缩应力下开裂。根据上述裂纹产生机理调整了某铸造镍基合金成分,合金的液化裂纹倾向性得到了改善。根据液化裂纹成因,采取了防止措施,在产品焊接上取得了良好效果。

     

    Abstract: The welding liquation cracks and the change of grain boundaries in HAZ of the cast Ni-base superalloy have been investigated by wide variety examinations,including metallograph,phase analysis,SEM,TEM,EPMA,etc.The mechanism of liquation cracking in some cast Ni-base superalloys is as follows.Under high welding temperature,the γ+γ' eutectic nearby the grain boundaries and the Zr rich low melting constituents in the front of eutectic reaction zone melted,and TiC nearby grain boundaries dissolved or partially dissolved and formed the constitutional liquation;these liquid phases flowed along the grain boundaries and the liquified grain boundaries,thus enhanced cracking under contracting stress.According to the above mentioned mechanism of liquation cracking in cast Nibase superalloy,the composition of M38 cast Ni-base superalloy was modified and its susceptibility to liquation cracking has been improved,some cther preventive measures against cracks were adopted and good results were obtained.

     

/

返回文章
返回