高级检索
罗志昌, 张麟, 李乃选, 闻人琪. Z向插销试验氢致延迟裂纹的研究[J]. 焊接学报, 1982, (3): 125-138.
引用本文: 罗志昌, 张麟, 李乃选, 闻人琪. Z向插销试验氢致延迟裂纹的研究[J]. 焊接学报, 1982, (3): 125-138.
Luo Zhichang, Zhang Lin, Li Naixuan, Wen Renqi. A STUDY ON HYDROGEN INDUCED DELAYED CRACKING WITH IMPLANT TEST IN Z-DIRECTION[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1982, (3): 125-138.
Citation: Luo Zhichang, Zhang Lin, Li Naixuan, Wen Renqi. A STUDY ON HYDROGEN INDUCED DELAYED CRACKING WITH IMPLANT TEST IN Z-DIRECTION[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 1982, (3): 125-138.

Z向插销试验氢致延迟裂纹的研究

A STUDY ON HYDROGEN INDUCED DELAYED CRACKING WITH IMPLANT TEST IN Z-DIRECTION

  • 摘要: 本文采用了Z向插销试验。对15MnVN钢和15MnVNCu钢的Z向抗裂性能进行了研究。试验结果表明.Z向插销临界应力值(σcr)z与母材的PCM和氢含量有关.该规律与反映氢致延迟裂纹本质的X向插销试验相同。作者利用断口分析和声发射技术证实:在本试验条件下(σcr)z主要是反映钢材的氢脆敏感性,而并非层状撕裂敏感性,同时认为,所采用的试验条件可以影响Z向插销试验所反映的实质。此外.文中还讨论了片条状MnS夹杂物在氢致延迟裂纹的形成和扩展时所起的作用,并对比了采用断裂准则和启裂准则的利弊.

     

    Abstract: Implant test in Z-direction was used to investigate the sensitivity of 15MnVN and 15MnVNCu steels to cracking in that direction.Experimental results showed that the critical stress of implant in Z-direction(σcr)z a was dependent on PCM of the base metal and the hydrogen content.This is just the same as in the case of implant test in X-direction,which reflects the essence of hydrogen induced delayed cracking.By means of fractographic analysis and acoustic emission technique,the authors confirmed that(σcr)z a indicated mainly the sensitivity to hydrogen embrittlement of steels rather than the sensitivity to lamellar tearing on our experimental conditions and the conditions would have an effect upon the significance of implant test in Z-direction.The role played by platelike M nS inclusions in the initiation and propagation of hydrogen induced delayed cracking was discussed and a comparison of the advantages and disadvantages of using rupture-criterion or crack-initiation-criterion was made.

     

/

返回文章
返回