高级检索
许良红, 田志凌, 彭云, 张晓牧. 焊后时效处理和固溶处理对接头组织和性能的影响[J]. 焊接学报, 2008, (2): 31-34.
引用本文: 许良红, 田志凌, 彭云, 张晓牧. 焊后时效处理和固溶处理对接头组织和性能的影响[J]. 焊接学报, 2008, (2): 31-34.
XU Lianghong, TIAN Zhiling, PENG Yun, ZHANG Xiaomu. Effect of heat treatment on microstructure and mechanical properties of high strength aluminum alloy welds[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2008, (2): 31-34.
Citation: XU Lianghong, TIAN Zhiling, PENG Yun, ZHANG Xiaomu. Effect of heat treatment on microstructure and mechanical properties of high strength aluminum alloy welds[J]. TRANSACTIONS OF THE CHINA WELDING INSTITUTION, 2008, (2): 31-34.

焊后时效处理和固溶处理对接头组织和性能的影响

Effect of heat treatment on microstructure and mechanical properties of high strength aluminum alloy welds

  • 摘要: 通过以2519高强铝合金为研究对象,研究了单独时效处理和固溶再时效处理对接头组织和性能的影响。结果表明,时效处理对接头的强度提升有一定的帮助,当时效温度为150℃时接头的抗拉强度达到最大;固溶再时效处理能使接头的抗拉强度显著增加,且随着固溶温度的增加,接头的抗拉强度随之增加,但当固溶温度达到540℃时,接头中容易产生液化裂纹,接头强度反而降低。采用强化固溶的方法,可以将固溶温度提升至540℃,显著提升接头的强度。

     

    Abstract: 2519 high strength aluminum alloy was welded, and the effect of aging treatment and solution treatment on the microstructure and mechanical properties were investigated.Results indicate that the aging treatment is helpful to improve the tensile strength of the joints, when the aging temperature is 150℃, and the tensile strength of the joints reach its max value.The tensile strength of the joints can be improved greatly by solution treatment, and with the increase of the solution temperature, the tensile strength of the joints increases.However, when the temperature reaches 540℃, liquid crack easily occurs, and the tensile strength will be decreased.The solution temperature can be improved to 540℃ by strength solution treatment, and the strength can reach 93%of that of the base metal.

     

/

返回文章
返回